HYS=DISABLE_, MODE=INACTIVE_NO_PULL_DO, INV=INPUT_NOT_INVERTED_, OD=DISABLE_, SLEW=STANDARD, FUNC=P1_26
I/O configuration register for pin P1[26]
| FUNC | Selects pin function for pin P1[26] 0 (P1_26): General purpose digital input/output pin. 1 (USB_SSPND1): USB port 1 Bus Suspend status (OTG transceiver). 2 (PWM1_6): Pulse Width Modulator 1, channel 6 output. 3 (T0_CAP0): Capture input for Timer 0, channel 0. 4 (MC_1B): Motor control PWM channel 1, output B. 5 (SSP1_SSEL): Slave Select for SSP1. 6 (LCD_VD_12): LCD data. 7 (LCD_VD_20): LCD data. |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE_NO_PULL_DO): Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN_RESISTOR_E): Pull-down resistor enabled. 2 (PULL_UP_RESISTOR_ENA): Pull-up resistor enabled. 3 (REPEATER_MODE_): Repeater mode. |
| HYS | Hysteresis. 0 (DISABLE_): Disable. 1 (ENABLE_): Enable. |
| INV | Invert input 0 (INPUT_NOT_INVERTED_): Input not inverted (HIGH on pin reads as 1, LOW on pin reads as 0). 1 (INPUT_INVERTED_HIGH): Input inverted (HIGH on pin reads as 0, LOW on pin reads as 1). |
| RESERVED | Reserved. |
| SLEW | Driver slew rate 0 (STANDARD): Standard mode, output slew rate control is enabled. More outputs can be switched simultaneously. 1 (FAST): Fast mode, slew rate control is disabled. Refer to the appropriate specific device data sheet for details. |
| OD | Open-drain mode. 0 (DISABLE_): Disable. 1 (OPEN_DRAIN_MODE_ENAB): Open-drain mode enabled. This is not a true open-drain mode. Input cannot be pulled up above VDD. |
| RESERVED | Reserved. |